The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage. Solidsfree oil-in-water （O/...The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage. Solidsfree oil-in-water （O/W） emulsion drilling fluid is one type of low-density drilling fluid suitable for depleted fractured reservoirs. In this paper, the solids-free O/W drilling fluid was developed and has been successfully used in the Bozhong 28-1 oil and gas field, by which lost circulation, a severe problem occurred previously when drilling into fractured reservoir beds, was controlled, thereby minimizing formation damage. The O/W emulsion drilling fluid was prepared by adding 20% （by volume） No. 5 mineral oil （with high flash point, as dispersed phase） into seawater （as continuous phase）. Surfactant HTO-1 （as a primary emulsifier） and non-ionic surfactant HTO-2 （as a secondary emulsifier） were added into the drilling fluid system to stabilize the emulsion; and YJD polymer was also added to seawater to improve the viscosity of the continuous phase （seawater）. The drilling fluid was characterized by high flash point, good thermal stability and high stability to crude oil contamination.展开更多
A method for the treatment of hazardous waste drilling fluids,potentially leading to environmental pollution,is considered.The waste drilling fluid is treated with an inorganic flocculant,an organic flocculant,and a p...A method for the treatment of hazardous waste drilling fluids,potentially leading to environmental pollution,is considered.The waste drilling fluid is treated with an inorganic flocculant,an organic flocculant,and a pH regulator.The profile control agent consists of partially hydrolyzed polyacrylamide,formaldehyde,hexamethylenetetramine,resorcinol,phenol,and the treated waste drilling fluid itself.For a waste drilling fluid concentration of 2500 mg/L,the gelling time of the profile control agent is 25 h,and the gelling strength is 32,000 mPa.s.Compared with the profile control agent prepared by recirculated water under the same conditions,the present profile control agent displays better stability,salt-resistance,and performance.展开更多
Potassium silicate drilling fluids （PSDF） are a waste product of the oil and gas industry with potential for use in land reclamation. Few studies have examined the influence of PSDF on abundance and composition of s...Potassium silicate drilling fluids （PSDF） are a waste product of the oil and gas industry with potential for use in land reclamation. Few studies have examined the influence of PSDF on abundance and composition of soil bacteria and fungi. Soils from three representative locations for PSDF application in Alberta, Canada, with clay loam, loam and sand textures were studied with applications of unused, used once and used twice PSDF. For all three soils, applying ≥40 m^3/ha of used PSDF significantly affected the existing soil microbial flora. No microbiota was detected in unused PSDF without soil. Adding used PSDF to soil significantly increased total fungal and aerobic bacterial colony forming units in dilution plate counts, and anaerobic denitrifying bacteria numbers in serial growth experiments. Used PSDF altered bacterial and fungal colony forming unit ratios of all three soils.展开更多
The global oil and gas industry has a long standing initiative to develop and use the most environment friendly solutions in the exploration and exploitation of oil and gas resources to prevent any damage or degradati...The global oil and gas industry has a long standing initiative to develop and use the most environment friendly solutions in the exploration and exploitation of oil and gas resources to prevent any damage or degradation of other marine and terrestrial resources. This is reflected by increasing research in academics, research institutes and organizations around the globe to develop better and more environment friendly base fluids, viscosifiers, fluid loss additives, emulsifiers, lubricants, etc. to protect the local, regional and global environments, eco-systems, habitats and also the OHS of workers and professionals working in the oil and gas industry. This paper describes the development, testing and evaluation of several novel additives to demonstrate their suitability for oil and gas field applications to avoid any negative impact to the surrounding environment. Experimental results indicate that the newly developed additives provide desirable, similar or better performance with respect to conventional additives used by the industry and thus demonstrate their suitability for application in aqueous and non-aqueous fluid design. The plant-based organic additive identified to use as an ecofriendly viscosifier for aqueous mud system can also control the fluid loss behavior of clay free system and thus can act as a bi-functional additive. Several waste vegetable oil-based eco-friendly additives have been developed for their application as spotting fluids, base oil and emulsifiers for invert emulsion oil based mud. These additives have similar or better technical performance than the equivalents and the eco-friendly nature of the mud additives demonstrates their ability to perform the functional tasks with better protection of the surrounding environments.展开更多
文摘The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage. Solidsfree oil-in-water （O/W） emulsion drilling fluid is one type of low-density drilling fluid suitable for depleted fractured reservoirs. In this paper, the solids-free O/W drilling fluid was developed and has been successfully used in the Bozhong 28-1 oil and gas field, by which lost circulation, a severe problem occurred previously when drilling into fractured reservoir beds, was controlled, thereby minimizing formation damage. The O/W emulsion drilling fluid was prepared by adding 20% （by volume） No. 5 mineral oil （with high flash point, as dispersed phase） into seawater （as continuous phase）. Surfactant HTO-1 （as a primary emulsifier） and non-ionic surfactant HTO-2 （as a secondary emulsifier） were added into the drilling fluid system to stabilize the emulsion; and YJD polymer was also added to seawater to improve the viscosity of the continuous phase （seawater）. The drilling fluid was characterized by high flash point, good thermal stability and high stability to crude oil contamination.
文摘A method for the treatment of hazardous waste drilling fluids,potentially leading to environmental pollution,is considered.The waste drilling fluid is treated with an inorganic flocculant,an organic flocculant,and a pH regulator.The profile control agent consists of partially hydrolyzed polyacrylamide,formaldehyde,hexamethylenetetramine,resorcinol,phenol,and the treated waste drilling fluid itself.For a waste drilling fluid concentration of 2500 mg/L,the gelling time of the profile control agent is 25 h,and the gelling strength is 32,000 mPa.s.Compared with the profile control agent prepared by recirculated water under the same conditions,the present profile control agent displays better stability,salt-resistance,and performance.
基金provided by Marquis Alliance Ltd. as part of a multi-disciplinary research program on environmental effects of PSDFsupported by a Ph.D. Scholarship from the China Scholarship Council
文摘Potassium silicate drilling fluids （PSDF） are a waste product of the oil and gas industry with potential for use in land reclamation. Few studies have examined the influence of PSDF on abundance and composition of soil bacteria and fungi. Soils from three representative locations for PSDF application in Alberta, Canada, with clay loam, loam and sand textures were studied with applications of unused, used once and used twice PSDF. For all three soils, applying ≥40 m^3/ha of used PSDF significantly affected the existing soil microbial flora. No microbiota was detected in unused PSDF without soil. Adding used PSDF to soil significantly increased total fungal and aerobic bacterial colony forming units in dilution plate counts, and anaerobic denitrifying bacteria numbers in serial growth experiments. Used PSDF altered bacterial and fungal colony forming unit ratios of all three soils.
文摘The global oil and gas industry has a long standing initiative to develop and use the most environment friendly solutions in the exploration and exploitation of oil and gas resources to prevent any damage or degradation of other marine and terrestrial resources. This is reflected by increasing research in academics, research institutes and organizations around the globe to develop better and more environment friendly base fluids, viscosifiers, fluid loss additives, emulsifiers, lubricants, etc. to protect the local, regional and global environments, eco-systems, habitats and also the OHS of workers and professionals working in the oil and gas industry. This paper describes the development, testing and evaluation of several novel additives to demonstrate their suitability for oil and gas field applications to avoid any negative impact to the surrounding environment. Experimental results indicate that the newly developed additives provide desirable, similar or better performance with respect to conventional additives used by the industry and thus demonstrate their suitability for application in aqueous and non-aqueous fluid design. The plant-based organic additive identified to use as an ecofriendly viscosifier for aqueous mud system can also control the fluid loss behavior of clay free system and thus can act as a bi-functional additive. Several waste vegetable oil-based eco-friendly additives have been developed for their application as spotting fluids, base oil and emulsifiers for invert emulsion oil based mud. These additives have similar or better technical performance than the equivalents and the eco-friendly nature of the mud additives demonstrates their ability to perform the functional tasks with better protection of the surrounding environments.
