Investigation of the trajectory uniformity in water dissolution ultraprecision continuous polishing of large-sized KDP crystal

Large-sized potassium dihydrogen phosphate(KDP)crystals are an irreplaceable nonlinear optical component in an inertial confinement fusion project.Restricted by the size,previous studies have been aimed mainly at the removal principle and surface roughness of small-sized KDP crystals,with less research on flatness.Due to its low surface damage and high machining efficiency,water dissolution ultraprecision continuous polishing(WDUCP)has become a good technique for processing large-sized KDP crystals.In this technique,the trajectory uniformity of water droplets can directly affect the surface quality,such as flatness and roughness.Specifically,uneven trajectory distribution of water droplets on the surface of KDP crystals derived from the mode of motion obviously affects the surface quality.In this study,the material removal mechanism of WDUCP was introduced.A simulation of the trajectory of water droplets on KDP crystals under different eccentricity modes of motion was then performed.Meanwhile,the coefficient of variation(CV)was utilized to evaluate the trajectory uniformity.Furthermore,to verify the reliability of the simulation,some experimental tests were also conducted by employing a large continuous polisher.The results showed that the CV varied from 0.67 to 2.02 under the certain eccentricity mode of motion and varied from 0.48 to 0.65 under the uncertain eccentricity mode of motion.The CV of uncertain eccentricity is always smaller than that of certain eccentricity.Hence,the uniformity of trajectory was better under uncertain eccentricity.Under the mode of motion of uncertain eccentricity,the initial surface texture of the100 mm×100 mm×10 mm KDP crystal did achieve uniform planarization.The surface root mean square roughness was reduced to 2.182 nm,and the flatness was reduced to 22.013μm.Therefore,the feasibility and validity of WDUCP for large-sized KDP crystal were verified.

Response surface method for modeling the removal of carbon dioxide from a simulated gas using water absorption enhanced with a liquid-film-forming device

This paper presents the results from using a physical absorption process to absorb gaseous CO2mixed with N2using water by producing tiny bubbles via a liquid-film-forming device（LFFD）that improves the solubility of CO2in water.The influence of various parameters—pressure,initial CO2concentration,gas-to-liquid ratios,and temperature—on the CO2removal efficiency and its absorption rate in water were investigated and estimated thoroughly by statistical polynomial models obtained by the utilization of the response surface method（RSM）with a central composite design（CCD）.Based on the analysis,a high efficiency of CO2capture can be reached in conditions such as low pressure,high CO2concentration at the inlet,low gas/liquid ratio,and low temperature.For instance,the highest removal efficiency in the RSM–CCD experimental matrix of nearly 80%occurred for run number 20,which was conducted at 0.30 MPa,CO2concentration of 35%,gas/liquid ratio of 0.71,and temperature of 15℃.Furthermore,the coefficients of determination,R^2,were 0.996 for the removal rate and 0.982 for the absorption rate,implying that the predicted values computed by the constructed models correlate strongly and fit well with the experimental values.The results obtained provide essential information for implementing this method properly and effectively and contribute a promising approach to the problem of CO2capture in air pollution treatment.