Strength weakening effect of high static pre-stressed granite subjected to low-frequency dynamic disturbance under uniaxial compression

This study aimed to elucidate the strength weakening effect of high static pre-stressed rocks subjected to low-frequency disturbances under uniaxial compression.Based on the uniaxial compressive strength(UCS)of granite under static loading,70%,80%,and 90%of UCS were selected as the initial high static pre-stress(σ_(p)),and then the pre-stressed rock specimens were disturbed by sinusoidal stress with amplitudes of 30%,20%,and 10%of UCS under low-frequency frequencies(f)of 1,2,5,and 10 Hz,respectively.The results show that the rockburst failure of pre-stressed granite is caused by low-frequency disturbance,and the failure strength is much lower than UCS.When theσp or f is constant,the specimen strength gradually decreases as the f or σ_(p) increases.The experimental study illustrates the influence mechanism of the strength weakening effect of high static pre-stress rocks under low-frequency dynamic disturbance,that is,high static pre-stress is the premise and leading factor of rock strength weakening,while low-frequency dynamic disturbance induces rock failure and affects the strength weakening degree.

Weakening effect of plastic yielding inception in thin hard coating systems

Hard coatings have been widely applied to enhance tribological performance of mechanical components.However,it was predicted that thin hard coatings may have a weakening effect which could reduce the coating/substrate system’s resistance to plastic yielding compared with the uncoated substrate material.In this paper,analytical simulation is utilized to investigate the origin of weakening effect.The functions of material mechanical properties and coating thickness on the weakening effect are theoretically investigated.Partial-unloading spherical nanoindentation tests are performed on tungsten coated single crystalline silicon and copper to acquire the stress-strain curves and compared with the uncoated cases.The experimental results are in consistence with the analytical solutions,demonstrating the presence of weakening effect.

Fault－weakening effect of reservoir temperature of hot spring and its influence on seismic activities

In this paper, the reservoir temperatures of 14 hot spring samples collected from the northern segment of theRed River Fault are calculated by using the mixing-model of SiO2-geothermometer. Based on the features ofreservoir temperatures and densities of hot springs, the northern segment of the Red River Fault is furtherdivided into 4 sub-segments. The influence of weakening effect of water on seismic activities is discussed fromthe view point of fault-weakening effect of water. It is suggested that the difference in seismic activity between various sub-segments is principally caused by the difference in intensity of the fault-weakening effect ofwater of these sub-segments. The Eryuan sub-segment where the reservoir temperatures are high and the hotsprings are dense corresponds to a slipped region, however, the Jianchuan and Midu sub-segments where thereservoir temperatures are lower and the hot springs are fewer as well as the Dan sub-segment where the hotspring are very few all correspond to locked regions. It is suggested that Dan sub-segment is the riskiest region for strong earthquake preparation, while the possibility for strong earthquake preparation is very little inthe Eryuan sub-segment.

Evaluation of the weakening behavior of gas on the coal strength and its quantitative influence on the coal deformation

The coal strength and deformation properties are key factors affecting safe coal mining and highefficiency coalbed methane(CBM)development.In this paper,reconstituted coal samples are chosen to investigate the weakening behavior of gas on coal strength,meanwhile,its effects on coal deformation are quantitatively evaluated.The results indicate that the weakening degree of gas on coal strength is closely related to the confining stress and gas pressure.Compared with non-gas-saturated coals,the maximum weakening ratios of adsorbed gas to coal strength are 10.58%,18.12%,8.55%and 14.65%under the conditions of confining stress CS=3 MPa and gas pressure GP=1 MPa,CS=3 MPa and GP=2 MPa,CS=4 MPa and GP=1 MPa,and CS=4 MPa and GP=2 MPa,respectively.Furthermore,the maximum weakening ratios of free gas to coal strength are 18.27%,36.54%,14.79%and 29.58%,respectively,under above four conditions.The maximum coal bulk strain decreases as particle sizes of coal powders increase,and it has a maximum value of 0.0227 and a minimum value of 0.0191 in particle size ranges of 0.01–0.041 and 0.5–1 mm.Under the same conditions,the coal bulk strain increases with increasing gas pressure,revealing that coal deformation properties can be enhanced by gas.