Effect of Width-to-Thickness Ratio and Thickness Profile Changing on the Critical Instable Shape During Cold Strip Rolling

Based on the volume constancy with equal flow-per-second and elastic sheet stability theory, a coupling relationship among lateral thickness difference, width-to-thickness ratio of cold rolling strip steel under ideal and actual working conditions, and shape is concluded according to the comprehensive influence principle of various factors on the critical instable shape analyzed in-depth. Firstly, the influence model under actual working condition is developed by referring to the basic relationship between lateral thickness difference and shape under ideal condition. The test results prove that for thin strips with thickness below 0.3 mm, their lateral thickness differences have significant effect on the shape. After then, the combined influence of lateral thickness difference and width-to-thickness ratio on the critical instable shape is concluded according to the elastic sheet stability model, with the synthetic effect of these three factors analyzed. Test data indicate that for cold rolling strip steel with width-to-thickness ratio above 3 000, the critical instability stress difference decreases significantly. Actual measurements are conducted on the lateral thickness differences of two rolls of typical strip manufactured by a sixhigh cold mill, with the influence law of lateral thickness variation and width-to-thickness ratio comprehensively investigated. It is demonstrated that during the production of ultrathin strip steel with different width-to-thickness ratios, the loading roll shapes should be fine adjusted according to the lateral thickness difference of input strips.Therefore, the variation of lateral thickness difference of output strips can meet the requirement of shape stability,so as to obtain fine shape.

Experimental study on the seismic behavior of high strength concrete fi lled double-tube columns

To study the seismic behavior of high strength concrete fi lled double-tube(CFDT) columns,each consisting of an external square steel tube and an internal circular steel tube,quasi-static tests on eight CFDT column specimens were conducted.The test variables included the width-to-thickness ratio(β1) and the area ratio(β2) of the square steel tube,the wall thickness of the circular steel tube,and the axial force(or the axial force ratio) applied to the CFDT columns.The test results indicate that for CFDT columns with a square steel tube with β1 of 50.1 and 24.5,local buckling of the specimen was found at a drift ratio of 1/150 and 1/50,respectively.The lateral force-displacement hysteretic loops of all specimens were plump and stable.Reducing the width-to-thickness ratio of the square steel tube,increasing its area ratio,or increasing the wall thickness of the internal circular steel tube,led to an increased fl exural strength and deformation capacity of the specimens.Increasing the design value of the axial force ratio from 0.8 to 1.0 may increase the fl exural strength of the specimens,while it may also decrease the ultimate deformation capacity of the specimen with β1 of 50.1.

Experimental research on behavior of 460 MPa high strength steel I-section columns under cyclic loading

To investigate the seismic behavior of I-section columns made of 460 MPa high strength steel （HSS）, six specimens were tested under constant axial load and cyclic horizontal load. The specimens were designed with different width-to-thickness ratios and loaded under different axial load ratios. For each specimen, the failure mode was observed and hysteretic curve was measured. Comparison of different specimens on hysteretic characteristic, energy dissipation capacity and deformation capacity were further investigated. Test results showed that the degradation of bearing capacity was due to local buckling of flange and web. Under the same axial load ratio, as width-to-thickness ratio increased, the deformation area of local buckling became smaller. And also, displacement level at both peak load and failure load became smaller. In addition, the full extent of hysteretic curve, energy dissipation capacity, ultimate story drift angle decreased, and capacity degradation occurred more rapidly with the increase of width-to-thickness ratio or axial load ratio. Based on the capacity of story drift angle, limiting values which shall not be exceeded are suggested respectively for flange and web plate of 460 MPa HSS I-section columns when used in SMFs and in IMFs in the case of axial load ratio no more than 0.2. Such values should be smaller when the axial load ratio increases.