A Structured Mesh Euler and Interactive Boundary Layer Method for Wing/Body Configurations

To compute transonic flows over a complex 3D aircraft configuration, a viscous/inviscid interaction method is developed by coupling an integral boundary-layer solver with an Eluer solver in a ＂semi-inverse＂ manner. For the turbulent boundary-layer, an integral method using Green＇s lag equation is coupled with the outer inviscid flow. A blowing velocity approach is used to simulate the displacement effects of the boundary layer. To predict the aerodynamic drag, it is developed a numerical technique called far-field method that is based on the momentum theorem, in which the total drag is divided into three component drags, i.e. viscous, induced and wave-formed. Consequently, it can provide more physical insight into the drag sources than the often-used surface integral technique. The drag decomposition can be achieved with help of the second law of thermodynamics, which implies that entropy increases and total pressure decreases only across shock wave along a streamline of an inviscid non-isentropic flow. This method has been applied to the DLR-F4 wing/body configuration showing results in good agreement with the wind tunnel data.

Aerodynamic Design Methodology for Blended Wing Body Transport

This paper puts forward a design idea for blended wing body（BWB）.The idea is described as that cruise point,maximum lift to drag point and pitch trim point are in the same flight attitude.According to this design idea,design objectives and constraints are defined.By applying low and high fidelity aerodynamic analysis tools,BWB aerodynamic design methodology is established by the combination of optimization design and inverse design methods.High lift to drag ratio,pitch trim and acceptable buffet margin can be achieved by this design methodology.For 300-passenger BWB configuration based on static stability design,as compared with initial configuration,the maximum lift to drag ratio and pitch trim are achieved at cruise condition,zero lift pitching moment is positive,and buffet characteristics is well.Fuel burn of 300-passenger BWB configuration is also significantly reduced as compared with conventional civil transports.Because aerodynamic design is carried out under the constraints of BWB design requirements,the design configuration fulfills the demands for interior layout and provides a solid foundation for continuous work.

Experimental and computational investigation of novel vertical tail buffet suppression method for high sweep delta wing

Our research aim is to investigate the buffet alleviation effect of static or vibrating bulges attached on the forebody surface of the model.Experiments and numerical simulations on a model consisting of a sharp-edged,70°-leading edge sweep delta wing and twin swept back vertical tails were conducted.Models with different bulges were tested and computed at 10 and 20 m/s of free stream velocity at angles of attack ranging from 20°–50°.Dynamic strain gauge and multichannel data acquisition and analysis system were employed for the measurement of unsteady root strain on the vertical tails.Experimental and computational results show that both static and vibrating bulges behave effectively as a novel tool to alleviate tail buffet,and the alleviation effect depends largely on the vibrating frequency.Besides,one-sided bulge can only alleviate the buffeting response for the tail of the same side,and it has no obvious alleviation effect for the opposite tail.Results of the spectral analysis reveal that there are generally three peaks of spectral density for aircrafts of this configuration,and bulges used in this paper could alleviate tail buffeting,but the total lift and drag of the whole model show no obvious deviation compared to the base model and the dominant frequency of the vibration of the tails has not shifted.