Y2O3-doped ZnO-based varistor ceramics were prepared using high-energy ball milling （HEBM） and low-temperature sin- tering technique, with voltage-gradient of 1934-2197 V/mm, non-linear coefficients of 20.8-21.8, le...Y2O3-doped ZnO-based varistor ceramics were prepared using high-energy ball milling （HEBM） and low-temperature sin- tering technique, with voltage-gradient of 1934-2197 V/mm, non-linear coefficients of 20.8-21.8, leakage currents of 0.59-1.04 μA, and densities of 5.46-5.57 g/cm3. With increasing Y2O3 content, the voltage-gradient increases because of the decrease of ZnO grain size; the non-linear coefficient and the leakage current improve but the density decreases because of more porosity; the donor con- centration and density of interface states decrease, whereas the barrier height and width increase because of the acceptor effect of Y2O3 in varistor ceramics.展开更多
ZnO-Bi2O3-based varistor ceramics doped with Yb2O3 in the range from 0 to 0.4% （molar fraction） were obtained by a solid reaction route. The X-ray diffractometry （XRD） and scanning electron microscopy （SEM） were...ZnO-Bi2O3-based varistor ceramics doped with Yb2O3 in the range from 0 to 0.4% （molar fraction） were obtained by a solid reaction route. The X-ray diffractometry （XRD） and scanning electron microscopy （SEM） were applied to characterize the phases and microstructure of the varistor ceramics, and a DC parameter instrument for varistor ceramics was applied to investigate their electrical properties and V-I characteristics. The XRD analysis of the samples shows that the ZnO phase, Bi2O3 phase, ZnTSbaOl2-type spinel phase and Zn2Bi3Sb3O14-type pyrochlore are present, and the Yb2O3 phases and Sb2O4 phases are found in varistor ceramics with increasing amounts of Yb2O3. The average size of ZnO grain firstly increases and then decreases with the increase of Yb2O3 content. The result also shows that the threshold voltage is between 656 V/nun and 1 232 V/mm, the nonlinear coefficient is in the range of 14.1-22.3, and the leakage current is between 0.60 μA and 19.6 μA. The 0.20% Yb2O3-added ZnO-Bi2O3-based varistor ceramics sintered at 900 ℃ have the best electrical characteristics.展开更多
Silver in the form of AgNO3 was added to ZnO-based varistor ceramics prepared by the solid-state reaction method.The effects of AgNO3 on both the microstructure and electrical properties of the varistors were studied ...Silver in the form of AgNO3 was added to ZnO-based varistor ceramics prepared by the solid-state reaction method.The effects of AgNO3 on both the microstructure and electrical properties of the varistors were studied in detail.The optimum addition amount of AgNO3 in ZnO-based varistors was also determined.The mechanism for grain growth inhibition by silver doping was also proposed.The results indicate that the varistor threshold voltage increases substantially along with the AgNO3 content increasing from 0 to 1.5mol%.Also,the introduction of AgNO3 can depress the mean grain size of ZnO,which is mainly responsible for the threshold voltage.Furthermore,the addition of AgNO3 results in a slight decrease of donor density and a more severe fall in the density of interface states,which cause a decline in barrier height and an increase in the depletion layer.展开更多
Microstructure and electrical properties of La2 O3-doped ZnO-Bi2 O3 thin films prepared by sol–gel process have been investigated.X-ray diffraction shows that most diffraction peaks of ZnO are equal,and the crystals ...Microstructure and electrical properties of La2 O3-doped ZnO-Bi2 O3 thin films prepared by sol–gel process have been investigated.X-ray diffraction shows that most diffraction peaks of ZnO are equal,and the crystals of ZnO grow well.Scanning electron microscopy and atomic force microscopy results indicate that the samples have a good structure and lower surface roughness.The nonlinear V–I characteristics of the films show that La2 O3 develops the electrical properties largely and the best doped content is 0.3% lanthanum ion,with the leakage current of 0.25 mA,the threshold field of 150 V/mm and the nonlinear coefficient of 4.0 in detail.展开更多
Nanosized ZnO powders were prepared with a two-step precipitation method. The average size of ZnO particles was about 80 nm and their size distribution was narrow. Combining with ultrafine additive powders, ZnO base v...Nanosized ZnO powders were prepared with a two-step precipitation method. The average size of ZnO particles was about 80 nm and their size distribution was narrow. Combining with ultrafine additive powders, ZnO base varistor was produced via an oxide mixing route. ZnO varistor derived from normal reagent grade starting materials was investigated for comparison purpose. Outstanding microstructure of the ZnO varistor derived from nanosize ZnO powders and ultrafine dopants was obtained: uniform distribution of fine ZnO grains (less than 3 microns), grain boundary and the dopant position. Higher varistor voltage (U=492 V/mm) and nonlinear coefficient (α=56.2) as well as lower leakage current (TL=1.5 μuA) were achieved. The better electrical properties were attributed to the uniform microstructure, which in turn led to stable and uniform potential barriers. Also this improved technique is more feasible for producing ZnO nanopowders and resulting varistor in large scales.展开更多
文摘Y2O3-doped ZnO-based varistor ceramics were prepared using high-energy ball milling （HEBM） and low-temperature sin- tering technique, with voltage-gradient of 1934-2197 V/mm, non-linear coefficients of 20.8-21.8, leakage currents of 0.59-1.04 μA, and densities of 5.46-5.57 g/cm3. With increasing Y2O3 content, the voltage-gradient increases because of the decrease of ZnO grain size; the non-linear coefficient and the leakage current improve but the density decreases because of more porosity; the donor con- centration and density of interface states decrease, whereas the barrier height and width increase because of the acceptor effect of Y2O3 in varistor ceramics.
基金Project(BK2011243) supported by the Natural Science Foundation of Jiangsu Province,ChinaProject(2007DA10512711408) supported by the Visiting Scholarship of State Key Laboratory of Power Transmission Equipment & System Security and New Technology (Chongqing University),China+4 种基金Project(EIPE11204) supported by the State Key Laboratory of Electrical Insulation and Power Equipment,ChinaProject(KF201104) supported by the State Key Laboratory of New Ceramic and Fine Processing,ChinaProject(KFJJ201105) supported by the Opening Project of State Key Laboratory of Electronic Thin Films and Integrated Devices,ChinaProject(10KJD430002) supported by the Universities Natural Science Research Project of Jiangsu Province,ChinaProject(11JDG084) supported by the Research Foundation of Jiangsu University,China
文摘ZnO-Bi2O3-based varistor ceramics doped with Yb2O3 in the range from 0 to 0.4% （molar fraction） were obtained by a solid reaction route. The X-ray diffractometry （XRD） and scanning electron microscopy （SEM） were applied to characterize the phases and microstructure of the varistor ceramics, and a DC parameter instrument for varistor ceramics was applied to investigate their electrical properties and V-I characteristics. The XRD analysis of the samples shows that the ZnO phase, Bi2O3 phase, ZnTSbaOl2-type spinel phase and Zn2Bi3Sb3O14-type pyrochlore are present, and the Yb2O3 phases and Sb2O4 phases are found in varistor ceramics with increasing amounts of Yb2O3. The average size of ZnO grain firstly increases and then decreases with the increase of Yb2O3 content. The result also shows that the threshold voltage is between 656 V/nun and 1 232 V/mm, the nonlinear coefficient is in the range of 14.1-22.3, and the leakage current is between 0.60 μA and 19.6 μA. The 0.20% Yb2O3-added ZnO-Bi2O3-based varistor ceramics sintered at 900 ℃ have the best electrical characteristics.
基金supported by the National Natural Science Foundation of China (Nos.50571059 and 50615024)the Natural Science Foundation of Jiangsu Province,China (No.SBK200920379)the Program for New Century Excellent Talents in Chinese Universities (No.NCET-07-0536)
文摘Silver in the form of AgNO3 was added to ZnO-based varistor ceramics prepared by the solid-state reaction method.The effects of AgNO3 on both the microstructure and electrical properties of the varistors were studied in detail.The optimum addition amount of AgNO3 in ZnO-based varistors was also determined.The mechanism for grain growth inhibition by silver doping was also proposed.The results indicate that the varistor threshold voltage increases substantially along with the AgNO3 content increasing from 0 to 1.5mol%.Also,the introduction of AgNO3 can depress the mean grain size of ZnO,which is mainly responsible for the threshold voltage.Furthermore,the addition of AgNO3 results in a slight decrease of donor density and a more severe fall in the density of interface states,which cause a decline in barrier height and an increase in the depletion layer.
基金Project(20123227120021)supported by the Specialized Research Fund for the Doctoral Program of Higher Education of ChinaProject(BK2012156)supported by the Natural Science Foundation of Jiangsu Province,China+3 种基金Project(KFJJ201105)supported by the Opening Project of State Key Laboratory of Electronic Thin Films and Integrated Devices,ChinaProject(CJ20125001)supported by the Application Program for Basic Research of Changzhou,ChinaProject(13KJB430006)supported by the Universities Natural Science Research project of Jiangsu Province,ChinaProject supported by the Industrial Center of Jiangsu University Undergraduate Practice-Innovation Training Program,China
文摘Microstructure and electrical properties of La2 O3-doped ZnO-Bi2 O3 thin films prepared by sol–gel process have been investigated.X-ray diffraction shows that most diffraction peaks of ZnO are equal,and the crystals of ZnO grow well.Scanning electron microscopy and atomic force microscopy results indicate that the samples have a good structure and lower surface roughness.The nonlinear V–I characteristics of the films show that La2 O3 develops the electrical properties largely and the best doped content is 0.3% lanthanum ion,with the leakage current of 0.25 mA,the threshold field of 150 V/mm and the nonlinear coefficient of 4.0 in detail.
文摘Nanosized ZnO powders were prepared with a two-step precipitation method. The average size of ZnO particles was about 80 nm and their size distribution was narrow. Combining with ultrafine additive powders, ZnO base varistor was produced via an oxide mixing route. ZnO varistor derived from normal reagent grade starting materials was investigated for comparison purpose. Outstanding microstructure of the ZnO varistor derived from nanosize ZnO powders and ultrafine dopants was obtained: uniform distribution of fine ZnO grains (less than 3 microns), grain boundary and the dopant position. Higher varistor voltage (U=492 V/mm) and nonlinear coefficient (α=56.2) as well as lower leakage current (TL=1.5 μuA) were achieved. The better electrical properties were attributed to the uniform microstructure, which in turn led to stable and uniform potential barriers. Also this improved technique is more feasible for producing ZnO nanopowders and resulting varistor in large scales.
