Analysis and improvement of missile three-loop autopilots

The non-minimum phase feature of tail-controlled missile airframes is analyzed. Three selection strategies for desired performance indexes are presented. An acceleration autopilot design methodology based on output feedback and optimization is proposed. Performance and robustness comparisons between the two-loop and classical three-loop topologies are made. Attempts to improve the classical three-loop topology are discussed. Despite the same open-loop structure, the classical three-loop autopilot shows distinct characteristics from a two-loop autopilot with PI compensator. Both the two-loop and three-loop topologies can stabilize a static unstable missile. However, the finite actuator resource is the crucial factor dominating autopilot function.

Modification of polarization filtering technique in HF ground wave radar

The polarization filter using three orthogonal linear polarization antennas can suppress more disturbances than the polarization filter using two orthogonal linear polarization antennas in HF ground wave radar. But the algorithm of the threedimension filter is relatively complicated and not suitable for real-time processing. It can＇t use linear and nonlinear polarization vector translation technique directly. A modified polarization filter which is simple and has same suppressing ability as the three-dimension polarization filter is given. It only has half parameters of the primary one. Some problems about estimation of polarization parameters and selection of disturbances are discussed. A method of holding the phase of radar backscatter signal constantly is put forward so that unstationary disturbance signal can be processed.

Study of trajectory optimization using terminal-node adaptive-altered spline algorithm

The advantage of using a spline function to evaluate the trajectory parameters optimization is discussed. A new method that using adaptive varied terminal-node spline interpolation for solving trajectory optimization is proposed. And it is validated in optimizing the trajectory of guided bombs and extended range guided munitions （ERGM）. The solutions are approximate to the real optimization results. The advantage of this arithmetic is that it can be used to solve the trajectory optimization with complex models. Thus, it is helpful for solving the practical engineering optimization problem.

General and efficient parallel approach of finite element-boundary integral-multilevel fast multipole algorithm

A general and efficient parallel approach is proposed for the first time to parallelize the hybrid finiteelement-boundary-integral-multi-level fast multipole algorithm （FE-BI-MLFMA）. Among many algorithms of FE-BI-MLFMA, the decomposition algorithm （DA） is chosen as a basis for the parallelization of FE-BI-MLFMA because of its distinct numerical characteristics suitable for parallelization. On the basis of the DA, the parallelization of FE-BI-MLFMA is carried out by employing the parallelized multi-frontal method for the matrix from the finiteelement method and the parallelized MLFMA for the matrix from the boundary integral method respectively. The programming and numerical experiments of the proposed parallel approach are carried out in the high perfor- mance computing platform CEMS-Liuhui. Numerical experiments demonstrate that FE-BI-MLFMA is efficiently parallelized and its computational capacity is greatly improved without losing accuracy, efficiency, and generality.

Design and performance analysis of networked control systems with random delay

The design and performance analysis of networked control systems with random network delay in the forward channel is proposed, which are described in a state-space form. A new control scheme is used to overcome the effects of network transmission delay, which is termed networked predictive control （NPC）. Furthermore, three different ways to choose control input are discussed and the performances are analyzed, respectively. Both real-time simulations and practical experiments show the effectiveness of the control scheme.

Research on the Hardware-in-the-loop Simulation of Guidance System

In this paper, the composition of the hardware-in-the-loop simulation system of missile guidance system and the characteristic and function of every equipment in this simulation system are discussed. Then the principle of this system is discussed in terms of theory, and the resemblance of prototype system with simulation system is analyzed. Also, many key problems such as equipment interface, equipment installation, modelling and software design are dealt with. At the end, the error source of simulation system is analyzed, and a strong base is built for the study of simulation system precision.

Reliability Optimization Design for the Safe-Arming System of an Air-Faced Missile

This paper establishes a mathematical model of the reliability optimization design for the safe-arming system of an air-faced missile, and presents a solving method for the model. The computational results provide a valuable reference for the reliability design for the safe-arming system of an air-faced missile.

Real-time detection of moving objects in video sequences

An approach to detection of moving objects in video sequences, with application to video surveillance is presented. The algorithm combines two kinds of change points, which are detected from the region-based frame difference and adjusted background subtraction. An adaptive threshold technique is employed to automatically choose the threshold value to segment the moving objects from the still background. And experiment results show that the algorithm is effective and efficient in practical situations. Furthermore, the algorithm is robust to the effects of the changing of lighting condition and can be applied for video surveillance system.

Study of the control-equilibrium of control systems

Not so much had been talked about equilibrium in control area. On the basis of the phenomenon of balance, the concept of control-equilibrium and control-equilibrium of a control system is proposed. According to this theory, a perfect control method should not only guarantee stability of the system, but also ensure the control-equilibrium of the system. To achieve the control-equilibrium, feed-forward control is required.

One modified method of characteristics used to analyze the multiconductor transmission lines

To solve the coupling effect of multiconductor transmission lines excited by external electromagnetic wave, the modified method of characteristics is proposed. The modified method of characteristics which can compute the terminal induced voltages excited by the external electromagnetic wave when the terminal networks or intereonnection networks contain the dynamic elements is introduced. The simulation results indicate that the modified method can analyze the terminal induced voltages when the terminal networks or the interconnection networks contain the dynamic elements excited by the external electromagnetic wave. And the results are compared with the results acquired by FDTD method, the two results are completely same. So one effective modified method is implemented to compute the transmission lines.

Unscented Kalman filter for SINS alignment

In order to improve the filter accuracy for the nonlinear error model of strapdown inertial navigation system (SINS) alignment, Unscented Kalman Filter (UKF) is presented for simulation with stationary base and moving base of SINS alignment. Simulation results show the superior performance of this approach when compared with classical suboptimal techniques such as extended Kalman filter in eases of large initial misalignment. The UKF has good performance in case of small initial misalignment.

Simulation research on scattering characteristics by complex targets

A simulation approach based on a full-wave numerical method is presented to study electromagnetic characteristics by complex targets. How to validate simulation results is considered thoroughly under no analytical and measured data, where a double-check criterion is designed for our simulation approach. As an example, the scattering of F-117A is studied by using our simulation approach under all polarizations, different frequency bands, incident and scattering directions, etc., some of which, such as cross-polarization, bistatic RCS, have not been considered in the previous literature.

Improved direct P code acquisition technique

P code direct acquisition is an important technology in satellite navigation system. As the P code has a long period, it is hard to directly acquire. The traditional average method can process multiple code phases in a time to shorten the acquisition time. But with the increase of average phase error of the input signal and the local code, the correlation signal-to-noise ratio （SNR） loss increases. To reduce the SNR loss, an improved average method is introduced. A new sequence is generated with a summation of phase shifting sequences to decrease correlation peak loss. Simulation results show that compared with direct average method, the improved average method effectively increases correlation SNR.

Narrow-band interference excision in spread-spectrum systems using new N-sigma algorithm based on fuzzy threshold

The key to narrow-band interference excision in frequency domain is to determine the excision thresh- old in direct-sequence spread-spectrum （DS-SS） systems. The excision threshold is a non-linear function related to the number and the power of interference, and attempting to get the exact relation of threshold related to the number and the power of interference is almost impossible. The N-sigma algorithm determines the excision threshold using subsection function; however, the excision threshold determined by this method is not exact. A new method to determine the threshold of N-sigma algorithm is proposed. The new method modifies the scale factor N by use of the membership function. The threshold determined by this method is consecutive and smooth, and it is closer to the fact than that of the initial N-sigma algorithm. The GPS signal and single-tone （CW） interference （that is, typical narrow-band interference） are implemented in the simulation, and the results are presented to demonstrate the validity of the new algorithm.

Study on the Hungarian algorithm for the maximum likelihood data association problem

A specialized Hungarian algorithm was developed here for the maximum likelihood data association problem with two implementation versions due to presence of false alarms and missed detections. The maximum likelihood data association problem is formulated as a bipartite weighted matching problem. Its duality and the optimality conditions are given. The Hungarian algorithm with its computational steps, data structure and computational complexity is presented. The two implementation versions, Hungarian forest （HF） algorithm and Hungarian tree （HT） algorithm, and their combination with the naYve auction initialization are discussed. The computational results show that HT algorithm is slightly faster than HF algorithm and they are both superior to the classic Munkres algorithm.

Self-organizing fuzzy clustering neural network and application to electronic countermeasures effectiveness evaluation

A self-organizing fuzzy clustering neural network by combining the self-organizing Kohonen clustering network with the fuzzy theory is proposed. This network model is designed for the effectiveness evaluation of electronic countermeasures, which not only exerts the advantages of the fuzzy theory, but also has a good ability in machine learning and data analysis. The subjective value of sample versus class is computed by the fuzzy computing theory, and the classified results obtained by self-organizing learning of Kohonen neural network are represented on output layer. Meanwhile, the fuzzy competition learning algorithm keeps the similar information between samples and overcomes the disadvantages of neural network which has fewer samples. The simulation result indicates that the proposed algorithm is feasible and effective.

Predictive control for mechanical system with backlash based on hybrid model

The mechanical system with backlash is distinguished between a＂backlash mode＂and a＂contact mode＂.The inherent switching between the two operating modes makes the system a prime example of hybrid system.For eliminating the bad effect of backlash, a piecewise affine（PWA） model of the mechanical servo system with backlash is built.The optimal control of constrained PWA system is obtained by taking advantage of model predictive control（MPC） method, and the explicit solution of MPC in a look-up table form is figured out by combining the dynamic programming and multi-parametric quadratic programming, thereby establishing an explicit hybrid model predictive controller.Furthermore, a piecewise quadratic（PWQ） function for guaranteeing the stability of closed-loop control is found by formulating the search of PWQ function as a semi-definite programming problem.In the tracking experiments, it is demonstrated that the explicit hybrid model predictive controller has a good traction control effect on the mechanical system with backlash.The error meets the demands of real system.Further, compared to the direct on-line computation, the computation burden is reduced by the explicit solution, thereby being suitable for real-time control of system with short sampling time.

Multicomponent Chirp Signal Detection Using Fractional Fourier Analysis

The aim of this paper is to propose a novel technique for the detection of multicomponent chirp signal and the parameter estimation based on fractional Fourier transform (FRFT). The relationship between the FRFT and the Wigner-Ville distribution (WVD) is investigated and the performance of the new approach is analyzed both in the computation complexity and the resolution in the fractional Fourier domain.

Multiple targets vector miss distance measurement accuracy based on 2-D assignment algorithms

An extension of 2-D assignment approach is proposed for measurement-to-target association for improving multiple targets vector miss distance measurement accuracy. When the multiple targets move so closely, the measurements can not be fully resolved due to finite resolution. The proposed method adopts an auction algorithm to compute the feasible measurement-to-target assignment with unresolved measurements for solving this 2-D assignment problem. Computer simulation results demonstrate the effectiveness and feasibility of this method.

Novel high-performance element in the electromagnetic finite-element method——node-edge element

It is known in the computational electromagnetics （CEM） that the node element has a relative wellconditioned matrix, but suffers from the spurious solution problem; whereas the edge element has no spurious solutions, but usually produces an ill-conditioned matrix. Particularly, when the mesh is over dense, the iterative solution of the matrix equation from edge element converges very slowly. Based on the node element and edge element, a node-edge element is presented, which has no spurious solutions and better-conditioned matrix. Numerical experiments demonstrate that the proposed node-edge element is more efficient than now-widely used edge element.