PREPARATION OF NOVEL POLYETHYLENE-graft-POLY(4-VINYLPYRIDINE)-SUPPORTED METALLOCENE CATALYSTS FOR ETHYLENE POLYMERIZATION

Polyethylene (PE) grafting 4-vinylpyridine copolymers has been produced as powders of different rushes by theirradiation method. After treatment with methylaluminoxane (MAO), the copolymers were used as supports for Cp_2ZrCl_2catalyst Results of X-ray photoelectron spectroscopy, Fourier transforms infrared spectroscopy, ultraviolet spectroscopy andscanning electron microscope measurements show that the catalytic sites have been linked through MAO on the PE-graft-4-vinylpyridine (PEVP). The percentages of grafting 4-vinylpyridine and supported Cp_2ZrCl_2 depend on the size ofpolyethylene powder. The smaller the polyethylene powder, the more percent of 4-vinylpyridine groups and Cp_2ZrCl_2 existon the polyethylene chains, and the PEVP-supported catalyst has a relatively high activity for ethylene polymerization.

STUDIES ON THE PORE FORMATION MECHANISM OF β-CRYSTALLINE POLYPROPYLENE UNDER STRETCHING

The pore formation mechanism of β-crystalline polypropylene under stretching was investigated. The porosity of the samples increases rapidly with stretching, having a maximum at draw ratios around 2 and then decreases monotonically. An abrupt formation process of initial micropores at very low draw ratios was evidenced by in situ SAXS measurements. At the same time the phase transition from β-crystal to α-crystal proceeds slowly in the whole deformation process up to large draw ratios around 5. Comparative studies of α-and β-crystalline polypropylene samples before stretching indicate that in addition to difference in crystal forms the α-and β-crystalline polypropylene samples exhibit quite different morphological features. There are a lot of interfaces in β-crystalline polypropylene samples, which may have a lower density value and can be easily etched by argon ions and penetrated by small molecules. It was concluded from these experimental facts that the pore formation and crystal transition are two independent phenomena during the deformation of β-crystalline polypropylene samples, and phase transition from β-crystal to α-crystal could hardly be the origin of pore formation. A defect initiation mechanism was proposed to understand the pore formation behavior of β-crystalline polypropylenes.

Fluorescence Spectra of Model Compounds for Light-emitting Alternating Copolymers in Heterogeneous Environments

In this paper, the fluorescence spectra of model compounds of light-emitting alternating copolymers. M (TPA-PPV) and M (TPA-PAV) (Scheme 1) were studied and the effect of KNO3 on the interaction between model compounds and ionic micelle-watts interface was also investigated. It is found that (I) The fluorescence changes of M (TPA-PPV) are related to the state of CTAB and SDS solution. (II)Aggregated state can be formed in M (TPA-PAV) solution at low concentration of CTAB. (III) Higher concentration of KNO3 may affect the interaction between model compounds and ionic micelle-water interface.

On-Line Multichannel Raman Spectroscopic Detection System For Capillary Zone Electrophoresis

An on-line multichannel Raman spectroscopic detection system for capillary electrophoresis was established by using an Ar+ laser and a cryogenically cooled ICCD. Resonant excitation Raman spectra of methyl red and methyl orange were employed to test the system. The result shows that it could yield on-line electrophoretogram and time series of Raman spectra.

Atomic Force Microscopy Studies on the Chemical Treatment of Nanocrystalline Porous TiO_2 Films

AFM has been utilized to study the surface topography and the local conductivity of nanocrystalline TiO2 films. Improving the local conductivity by Ti(iso-C3H7O)4 treatment is characterized by quantitative analysis of the simultaneous current image. The mechanism of Ti(iso C3H7O)4 treatment is discussed.

Impedance Characterization of the Film Formation Process at the Graphite Anodes

In this paper, the formation mechanism of the passive SEI film at the natural graphite anodes was investigated with tilt: electrochemical impedance spectroscopy (EIS). A characteristic semicircle was observed in the lower frequency range of the EIS spectrum for the irreversible charge process (lithium intercalation) at ca. 0.75V, 0.40V and 0.20V.

SYNTHESIS AND CHARACTERIZATION OF A NOVEL DOPANT (C3-ABSA) FOR SYNTHESIZING TUBULAR POLYANILINE

4-(3-(4-((4-Nitrophenyl)azo)phenyloxy)propyl)aminobenzene sulfonic acid (C3-ABSA) was synthesized by the reaction of 3-bromide-1-(4-((4-nitrophenyl)azo)phenyloxy)propane (B3) with sodium p-aminobenzene sulfonic acid (ABSA) and acidification with hydrochloric acid. The C3-ABSA was characterized by FTIR, H-1-NMR and second ion mass spectrum (SIMS). The molecular formula of dehydrated C3-ABSA was estimated to be ca. C21H20O6N4S by SIMS. Its decomposition temperature was measured by TGA to be ca. 232 degreesC. It was found that tubular polyaniline (PANI) with a conductivity of 1.1 S/cm at room temperature was successfully synthesized by in-situ doping polymerization in the presence of C3-ABSA as a dopant.

OBSERVATION OF DNA PARTIAL DENATURATION BY ATOMIC FORCE MICROSCOPY

Atomic force microscopy was used to investigate the DNA-cetyltrimethylammonium bromide (CTAB) complexes adsorbed on highly ordered pyrolytic graphite (HOPG). These complexes, at low concentrations, can automatically spread out on the surface of HOPG. The DNA-CTAB complexes display a typically extended structure rather than a globular structure. Partially denaturated DNA produced by binding CTAB to DNA is directly observed by AFM with high resolution. The three-dimensional resolution of partially denaturated DNA obtained by AFM is not available by any other technique at present.

High Performance Affinity Chromatography of Antithrombin III Based on Monodisperse Poly (glycidyl methacrylate) Beads

A new approach for the separation of antithrombin III with high performance affinity chromatography (HPAC) was described. A novel monodisperse, non-porous, cross-linked poly (glycidyl methacrylate) beads (PGMA) were used as the affinity support. With the water-soluble carbodiimide, heparin was linked covalently to amino-PGMA-beads, which was prepared by amination of PGMA. The adsorbent obtained exhibits high binding activity to antithrombin III (ATIII), good resolution and excellent mechanical properties and can be used under high flow rate.

Phase Selectively Soluble Dendritic Derivative of 4-(Dimethylamino)- pyridine: An Easily Recyclable Catalyst for Baylis-Hillman Reactions

A new thermomorphic catalytic system for the Baylis-Hillman coupling of aromatic aldehydes with a, β-unsaturated ketone has been described, in which the alkyl-functionalized dendritic catalyst preferred to dissolve in non-polar organic layer in the thermomorphic biphasic system, leading to easy separation of the catalyst from the polar products by changing the temperature of the system at end of the reaction.

Synthesis and Conformational Properties of Bis(calix[4]arene)

The bis(calix[4]arene) 3 was synthesized in moderate yield by the reaction of p-tert-butylcalix[4]arene (1) with 1,4-bis(chloromethyl)benzene (2). The conformation of all alkylated product 4 was investigated by the variable-temperature 1H-NMR.

THE BEHAVIOR OF HOMOGENEOUS IRON-BASED CATALYSTS BEARING PYRIDINE DIIMINE LIGANDS FOR ETHYLENE POLYMERIZATION

The polymerization of ethylene by two iron-based catalysts, {[2,6-ArN=C(Me)(2)C5H3N]FeCl2} (Ar = 2,6-C6H3-Me-2 I; 2,6-C6H3 (i-Pr)(2) II) has been investigated. Catalyst II produces higher molecular weight polyethylene (PE) and broadened polydispersities relative to catalyst I under analogous conditions and all polymers are linear. The kinetic profiles with iron catalysts showed a smooth pattern during both rate build-up and rate lowering, which are different from the metallocene catalysts. The polymerization activity increases with Al/Fe value and an optimum temperature range at 40 similar to 45 degreesC was observed. The molecular weight of PE decreases with the increase of Al/Fe ratio and rise of polymerization temperature.

Explanation of Effect of Added Water on Dye-Sensitized Nanocrystalline TiO2 Solar Cell： Correlation between Performance and Carrier Relaxation Kinetics

Time-resolved mid-IR transient absorption spectroscopy is employed to explore the mechanism of improving the performance of dye-sensitized TiO2 solar cell （DSSC） when a certain amount of H2 0 is added into the electrolyte. The relaxation kinetics of dye-sensitized TiO2 nanocrystalline film and the corresponding DSSC performance are investigated under different conditions. It is found that the interracial charge recombination is retarded and electron injection efficiency is increased in the water vapour and in the electrolyte when D20 is added. The values of open-circuit photovoltage Voc and the short-circuit photocarrent Jsc of the cells are linearly correlated to the product of the two decay time constants. We also observed that Voc well correlates with electron injection efficiency. It provides a preliminary microscopic account for the function of the added water in improving the performance of DSSCs.

Enhancement of Formation of Polar Microenvironment in Polymer by Compressed CO_(2)

The copolymer (EO)22(PO)52(EO)22 in p-xylene can solubilize much more water in the presence of compressed CO2 than the case without CO2.

SYNTHESIS OF ORGANOMETALLIC PRECURSORS FOR Si/Zr/C/N-BASED CERAMICS

A new kind of organometallic precursor for Si/Zr/C/N-based ceramics was synthesized from the amine exchangereaction of hexamethylcyclotrisilazane (D_3~N) and tetrakis(diethylamino) zirconium (Zr[NEt_2]_4). Pyrolysis was performedunder nitrogen at 800℃ in a tube furnace equipped with a temperature program controller. The highest pyrolytic yield was67.5%.

Silazyl-Lithiums: A kind of new Initiators for the Anionic Non- equilibrium Ring-opening Polymerization of Octamethylcyclotetrasiloxane (D_4)

The initiation reactions in the anionic non-equilibrium polymerization of octamethy- lcyclotetrasiloxane (D4) initiated by silazyllithiums were investigated. It was found that the structure of the substituents on the Si atom had great influences on the initiation activity of silazyllithiums.

Molecular Dynamics Simulation of Glass Transition Behavior of Polyimide Ensemble

The effect of chromophores to the glass transition temperature of polyimide ensemble has been investigated by means of molecular dynamics simulation in conjunction with barrier analysis. Simulated Tg results indicated a good agreement with experimental value. This study showed the MD simulation could estimate the effect of chromophores to the Tg of polyimide ensemble conveniently and an estimation approach method had a surprising deviation of Tg from experiment. At the same time, a polyimide structure with higher barrier energy was designed and validated by MD simulation.

Imidazoles: Effective Catalysts for Baylis-Hillman Reaction in Aqueous Media

β-Substituted enones have been considered less reactive in Baylis-Hillman reaction. The reaction of cyclic enones is sluggish or does not occur at all under traditional conditions. Various catalysts have been developed to pro mote the reaction of cyclic enones but with limited success. In previous study, we found that imidazole can catalyze the Baylis-Hillman reaction involving cyclic enones in aqueous THF solution.[1] In our continued efforts, we screened a variety of imidazoles to develop superior catalyst, and we found that the reaction could be greatly accelerated by adjusting the pH value of the water solution.……