Solving Two Kinds of JC Models Relating to Two-Photon Process by Supersymmetric Transformation

We propose two kinds of new Jaynes Cummings models relating to two-photon process by using the supersymmetric unitary transformation. The corresponding energy eigenvalues and eigenvectors are obtained.

RESEARCH ON HOT FORMING PROCESS OF A RETAINING RING OF HIGH-NITROGEN STEEL

Mn18Cr18N, the high-nitrogen steel, is the 2nd generation material for manufacturing the retaining ring of firepower generators. In this paper, the hot deformation behavior of the material was investigated by thermo-mechanical modeling tests. And the flow stress curves of the steel were obtained for various combinations of the temperature and strain rate. Based on the results of the tests, the complex forming process of a retaining ring including punching, expanding and extrusion with an enclosure was put forward and simulated by means of numerical simulation method. The results indicate that the process is a novel and force-saved practical technology for manufacturing heavy retaining rings.

Room-temperature mechanical properties of WSi_2/MoSi_2 composites

Five kinds of WSi_2/MoSi_2 composites were successfully prepared bymechanical alloying, IP and high temperature sintering techniques. And their hardness and fracturetoughness were measured by the Vickers indentation fracture mode through an Hv-10A type sclerometer.The microstructure and morphology were investigated by a JSM-56001V scanning electron microscope.Results show that the addition of 50% WSi_2 (in mole fraction) has remarkable hardening andtoughening effects on the MoSi_2 matrix, whose hardness value and fracture toughness value areincreased about 60% and 86%, respectively. For WSi_2/MoSi_2 composite, the hardening mechanisms arefine-grain and the second phase particles strengthening, and the toughening mechanisms includefine-grain, grain drawing, crack deflection, microbridge and bowing toughening.

Gas phase tricholoethylene removal at low concentration using activated carbon fiber

The breakthrough adsorption behaviors of gas phase trichloroethylene in a packed bed of activated carbon fibers(ACF) were investigated. The specific surface area of the ACF was 600 m 2/g, 1400 m 2/g and 1600 m 2/g, respectively, and the concentration of trichloroethylene ranged from 270 mg/m 3 to 2700 mg/m 3. Results showed that the capacity of adsorption increased with increasing specific surface area, the relationship between the logarithms of 10% breakthrough time and concentration was approximately linear over the experimental range, the breakthrough time decreased with increasing temperature and humidity. The breakthrough curves at different inlet concentration or different temperature can be predicted by several simple theoretical models with good agreements.

Preparation of Porous Alumina Film on Aluminum Substrate by Anodization in Oxalic Acid

Self-ordering of the cell arrangement of the anodic porous alumina was prepared in oxalic acid solution at a constant potential of 40V and at a temperature of 20C. The honeycomb structure made by one step anodization method and two step anodization method is different. Pores in the alumina film prepared by two step anodization method were more ordered than those by one step anodization method.

New Bosonic Operator Ordering Identities Gained by the Entangled State Representation and Two－Variable Hermite Polynomials

Based on the technique of integration within an ordered product of operators, we derive new bosonic operators, ordering identities by using entangled state representation and the properties of two-variable Hermite polynomials , and vice versa. In doing so, some concise normally (antinormally) ordering operator identities, such as : are obtained.

New Eigenmodes of Propagation in Quadratic Graded Index Media and Complex Fractional Fourier Transform

By introducing a convenient complex form of the α-th 2-dimensional fractional Fourier transform (CFFT) operation we find that it possesses new eigenmodes which are two-mode Hermite polynomials. We prove the eigenvalues of propagation in quadratic graded-index medium over a definite distance are the same as the eigenvalues of the α-th CFFT, which means that our definition of the α-th CFFT is physically meaningful.

Nickel Oxide as an Electrode Material for Supercapacitors

The preparation of Ni oxide films and their capacitive mechanism are discussed in this paper. Nickel oxide film electrodes perform pseudocapacitance in aqueous KOH and NaOH but perform double layer capacitance in LiCIO4/PC (propylence carbonate). The effect of increasing the specific capacitance was observed when Ni oxide film electrodes are doped with Co. A specific capacitance of around 70 F/g was achieved when using Ni oxide films doped with Co as electrodes and 1 mol/L aqueous KOH or NaOH as an electrolyte.

Experimental and Finite Element Method Studies of J-Lead Solder Joint Reliability

A comprehensive experimental and numerical study of solder joints for plastic leaded chip carrier (PLCC) 84-Pin, 1.27 mm pitch was carried out. The reliability of solder joints was assessed through accelerated thermal cycling at the temperature range of - 55℃-125℃. The samples were taken out to observe the evolution in microstructure, such as grain coarsening, initiation and propagation of cracks. It was found that the Pb-rich phases segregated gradually and formed a continuous layer adjacent to the intermetallic compound (IMC) layer with increasing the number of thermal cycles, resulting in cracks near the solder/lead interface. The response of stress and strain was studied using nonlinear finite element method (FEM), and the results agreed well with the experimental data.

Carbon Nanotubes Grown on Sepiolite as Catalyst Carrier

Multi-walled carbon nanotubes were synthesized by the catalytic decomposition of acetylene at 750oC over sepiolite powder, which was treated with aqueous cobalt nitrate. It is expected that the composite with high specific area will have high capacity of hydrogen storage.

Precise Determination of the MgAlON/(AlN+MgAlON) Phase Bound- ries in the MgO-AlN-Al_2O_3 Ternary System at 1600℃ and 1700℃

The accurate phase boundary of MgAION/(AIN+MgAION) in MgO-AIN-Al2O3 ternary system, has not been determined precisely so far. In the present study, the lattice parameters of MgAION solid solution with various compositions were determined precisely with X-ray powder diffraction. According to the relationship between the lattice parameters of MgAION solid solution and the contents of AIN and MgO, the phase boundaries of MgAION/(AIN+MgAION) in MgO-AIN-AI2O3 ternary system at 1600℃ and 1700℃ were precisely determined.

Classical Information Capacities of Some Single Qubit Quantum Noisy Channels

By using the Holevo-Schumacher-Westmoreland theorem and through solving eigenvalues of states out from the quantum noisy channels directly, or with the help of the Bloch sphere representation, or Stokes parametrization representation, we investigate the classical information capacities of some well-known quantum noisy channels.

Residual Stress Improved by Water Jet Peening for A Quenched Gear

In this paper, a running cost is cheap from the thing used for harmless peening treatment to the environment, health which an influence is rare in toward processing material like heat being only water fundamentally, and economical, and the characteristics is hard to get are given. There is some research about the residual stress improvement by water-jet peening during the high-speed water. In this study, a big bubble cloud ceremony water-jet peening which dissolves the problem of the form of the applicable thing by exposing the whole of the applicable thing in the big bubble cloud as the way of dealing with peening efficiently in a short time is proposed by this research. Moreover, the uniform compression residual stress is added around the surface of the processing side, and connected with the remarkable improvement of the fatigue strength of the part. Furthermore, and safety processing is very possible, and it thinks about the thing which has possible high practical use, and writers to get rid of the problems of the way of processing it with peening until now. Water-jet peening was given by this research during high-speed water with big bubble cloud-type water toward tooth gear manufactured by SCr420H3 V2 to open the effect of water-jet peening during the high-speed water. A change was measured at the time as the sutra of the residual stress on the surface of the test settlement by the X-ray method, and the validity of this law was verified.

Synthesis of a Photolabeling Probe for the Study of Antiviral Mechanism of Ribavirin

Ribavirin has been used in urgency to treat SARS patients recently. In order to study its antiviral mechanism by photolabeling approach, we have synthesized and characterized 5-azido-1-β-D-ribofuranosyl-1,2,4-triazole-3-carboxiamide 1 as a photolabeling probe of ribavirin. The azidotriazole nucleoside showed rapid and clean photochemical reaction, suggesting that l is a promising probe to study the antiviral mechanism of ribarivin by photolabeling.

Fractional Fourier Transformation for Quantum Mechanical Wave Functions Studied by Virtue of IWOP Technique

Starting from the optical fractional Fourier transform (FFT) and using the technique of integration withinan ordered product of operators we establish a formalism of FFT for quantum mechanical wave functions. In doing so, theessence of FFT can be seen more clearly, and the FFT of some wave functions can be derived more directly and concisely.We also point out that different FFT integral kernels correspond to different quantum mechanical representations. Theyare generalized FFT. The relationship between the FFT and the rotated Wigner operator is studied by virtue of theWeyl ordered form of the Wigner operator.

Generalized Bargmann Representation of Spin Coherent State

Based on the conclusion that the generalized Bargmann representation of a two-mode Fock state is a two-variable Hermite polynomial function /Hong-Yi Fan and Jun-hua Chen,Phys.Lett.A303(2002)311] we derive the generalized Bargmann representation of the spin coherent state and some new relations in the generalized function space.

Fractional Radon Transform and Transform of Wigner Operator

Based on the Radon transform and fractional Fourier transform we introduce the fractional Radon trans-formation (FRT). We identify the transform kernel for FRT. The FRT of Wigner operator is derived, which naturallyreduces to the projector of eigenvector of the rotated quadrature in the usual Radon transform case.

Effect of strong carbide forming elements in hardfacing weld metal

To achieve high carbon hard-facing weld metals with both high hardness andcrack resistance, strong carbide forming elements Ti, Nb and V were alloyed into the weld metals,and their effect on the formation of carbides and the matrix microstructure were studied. ElectronProbe Microanalysis (EPMA), Energy Dispersive Spectroscopy(EDS) and Transmission ElectronMicros-copy(TEM) were adopted to investigate the microstructure, then thermodynamics of theformation of carbides was calculated and their effect on the matrix was further discussed. It isrevealed that Nb, Ti and V influence strongly the distribution and existing state of carbon,inducing precipitation of carbides accompanying with the depletion of carbon in matrix. But whenonly V are alloyed as carbide forming element, the carbides are scarce and distributed along grainboundaries, and the hard-facing alloy is too hard, while the using of only Nb or Ti could notreinforce the weld metals effectively. The hard-facing alloy reinforced with Nb, V and Ti can formdispersive fine carbides and low carbon martensite matrix.

One-Sided Squeezing for Two Special Kinds of Tripartite Entangled States

Based on two mutual conjugate tripartite entangled states |η, σ〉θ and |ζ, τ〉θ we generalize the two-mode one-sided squeezing operators to three-mode case. We derive how the tripartite entangled states transform under the three-mode squeezing operators. We conclude that the entangled state representations provide a convenient basis for deriving various three-mode squeezing operators.