Similar reservoir sandbodies and fault conduit systems in the sandstone reservoirs in the middle Es3 member of the Niuzhuang Sag have been problematic for a long time. The following problems remain unsolved： 1） The ...Similar reservoir sandbodies and fault conduit systems in the sandstone reservoirs in the middle Es3 member of the Niuzhuang Sag have been problematic for a long time. The following problems remain unsolved： 1） The distribution of sandstone porosity is inconsistent with the hydrocarbon accumulation. The oil sandstones have low porosity instead of high porosity. 2） Sandstones, which have the same properties, have different levels of oiliness, and the sandstones with almost the same properties show different degrees of oil-bearing capacity. This study analyzes the condition of reservoirs in the research area during the accumulation period in terms of paleoporosity estimation and discusses the critical porosity of the sandstone reservoirs during the same period. The following conclusions can be drawn from the results. 1） Although reservoir properties are low at present and some reservoirs have become tight, the paleoporosity ranging from 18% to 25% is greater than the critical porosity of 13.9%. As the： loss of porosity is different in terms of burial history, the present porosity cannot reflect porosity during the accumulation period. Similar/y, high porosity during the accumulation period does not indicate that tbe present porosity is high. 2） The present reservoir location is consistent with the distribution of high paleoporosity during the accumulation period. This result indicates that high porosity belts are prone to hydrocarbon accumulation because of the dominant migration pathways generated as a result of property discrepancies under similar fault conduit conditions. Consequently, the hydrocarbon mainly accumulates in high porosity belts. Paleoporosity during the accumulation period is found to be a vital controlling factor. Therefore, high paleoporosity sandstones in the middle Es3 member of the Niuzhuang Sag have great potential for future exploration.展开更多
Fluid inclusions from samples from the layered and veined mineralized belt in the Mopan mine area were studied using microscopic temperature measurements and laser Raman spectroscopy.Further studies were conducted on ...Fluid inclusions from samples from the layered and veined mineralized belt in the Mopan mine area were studied using microscopic temperature measurements and laser Raman spectroscopy.Further studies were conducted on the nature and source of the ore forming fluid and on the mechanism of deposit formation.The results show that there are three types of inclusions that occur in both the layered and veined ore body.These are liquid inclusions,CO 2 inclusions with a liquid phase,and NaCl-H 2 O multiphase inclusions.The fluid inclusions in both the layered and veined ore bodies have similar characteristics.The ore forming fluid is strongly reducing,was exposed to low to medium temperatures,salinity,and pressures.The source of this ore forming fluid was a mix of submarine volcanic spring(blow-piping),magmatic hydrothermal jet,and underground water.展开更多
The types,evolution processes,formation mechanisms,and depositional models of deep-water gravity flow deposits in a lacustrine rift basin are studied through core observation and systematic analysis.Massive transport ...The types,evolution processes,formation mechanisms,and depositional models of deep-water gravity flow deposits in a lacustrine rift basin are studied through core observation and systematic analysis.Massive transport of slide and slump,fluid transport of debris flow and turbidity currents are driven by gravity in deep-water lacustrine environment.The transformation between debris flow and turbidity current,and the transformation of turbidity current between supercritical and subcritical conditions are the main dynamic mechanisms of gravity flow deposits in a lake basin.The erosion of supercritical turbidity current controls the formation of gravity-flow channel.Debris flow deposition gives rise to tongue shape lobe rather than channel.Deep-water gravity flow deposits are of two origins,intrabasinal and extrabasinal.Intrabasinal gravity flow deposits occur as single tongue-shape lobe or fan of stacking multiple lobes.Extrabasinal gravity-flow deposits occur as sublacustrine fan with channel or single channel sand body.However,the nearshore subaqueous fan is characterized by fan of stacking multiple tongue shape lobes without channel.The differential diagenesis caused by differentiation in the nearshore subaqueous fan facies belt results in the formation of diagenetic trap.The extrabasinal gravity flow deposits are one of the important reasons for the abundant deep-water sand bodies in a lake basin.Slide mass-transport deposits form a very important type of lithologic trap near the delta front often ignored.The fine-grained sediment caused by flow transformation is the potential"sweet spot"of shale oil and gas.展开更多
基金supported by the Young Scholars Development Fund of SWPU
文摘Similar reservoir sandbodies and fault conduit systems in the sandstone reservoirs in the middle Es3 member of the Niuzhuang Sag have been problematic for a long time. The following problems remain unsolved： 1） The distribution of sandstone porosity is inconsistent with the hydrocarbon accumulation. The oil sandstones have low porosity instead of high porosity. 2） Sandstones, which have the same properties, have different levels of oiliness, and the sandstones with almost the same properties show different degrees of oil-bearing capacity. This study analyzes the condition of reservoirs in the research area during the accumulation period in terms of paleoporosity estimation and discusses the critical porosity of the sandstone reservoirs during the same period. The following conclusions can be drawn from the results. 1） Although reservoir properties are low at present and some reservoirs have become tight, the paleoporosity ranging from 18% to 25% is greater than the critical porosity of 13.9%. As the： loss of porosity is different in terms of burial history, the present porosity cannot reflect porosity during the accumulation period. Similar/y, high porosity during the accumulation period does not indicate that tbe present porosity is high. 2） The present reservoir location is consistent with the distribution of high paleoporosity during the accumulation period. This result indicates that high porosity belts are prone to hydrocarbon accumulation because of the dominant migration pathways generated as a result of property discrepancies under similar fault conduit conditions. Consequently, the hydrocarbon mainly accumulates in high porosity belts. Paleoporosity during the accumulation period is found to be a vital controlling factor. Therefore, high paleoporosity sandstones in the middle Es3 member of the Niuzhuang Sag have great potential for future exploration.
文摘Fluid inclusions from samples from the layered and veined mineralized belt in the Mopan mine area were studied using microscopic temperature measurements and laser Raman spectroscopy.Further studies were conducted on the nature and source of the ore forming fluid and on the mechanism of deposit formation.The results show that there are three types of inclusions that occur in both the layered and veined ore body.These are liquid inclusions,CO 2 inclusions with a liquid phase,and NaCl-H 2 O multiphase inclusions.The fluid inclusions in both the layered and veined ore bodies have similar characteristics.The ore forming fluid is strongly reducing,was exposed to low to medium temperatures,salinity,and pressures.The source of this ore forming fluid was a mix of submarine volcanic spring(blow-piping),magmatic hydrothermal jet,and underground water.
基金Supported by the National Natural Science Foundation of China(41802127,U1762217)China National Science and Technology Major Project(2016ZX05006-003)。
文摘The types,evolution processes,formation mechanisms,and depositional models of deep-water gravity flow deposits in a lacustrine rift basin are studied through core observation and systematic analysis.Massive transport of slide and slump,fluid transport of debris flow and turbidity currents are driven by gravity in deep-water lacustrine environment.The transformation between debris flow and turbidity current,and the transformation of turbidity current between supercritical and subcritical conditions are the main dynamic mechanisms of gravity flow deposits in a lake basin.The erosion of supercritical turbidity current controls the formation of gravity-flow channel.Debris flow deposition gives rise to tongue shape lobe rather than channel.Deep-water gravity flow deposits are of two origins,intrabasinal and extrabasinal.Intrabasinal gravity flow deposits occur as single tongue-shape lobe or fan of stacking multiple lobes.Extrabasinal gravity-flow deposits occur as sublacustrine fan with channel or single channel sand body.However,the nearshore subaqueous fan is characterized by fan of stacking multiple tongue shape lobes without channel.The differential diagenesis caused by differentiation in the nearshore subaqueous fan facies belt results in the formation of diagenetic trap.The extrabasinal gravity flow deposits are one of the important reasons for the abundant deep-water sand bodies in a lake basin.Slide mass-transport deposits form a very important type of lithologic trap near the delta front often ignored.The fine-grained sediment caused by flow transformation is the potential"sweet spot"of shale oil and gas.
