Two experimental techniques have been used to quantify the atomic oxygen density in the case of hot air plasma generated by a microwave （MW） resonant cavity. The latter operates at a frequency of 2.45 GHz inside a c...Two experimental techniques have been used to quantify the atomic oxygen density in the case of hot air plasma generated by a microwave （MW） resonant cavity. The latter operates at a frequency of 2.45 GHz inside a cell of gas conditioning at a pressure of 600 mbar, an injected air flow of 12 L/min and an input MW power of 1 kW. The first technique is based on the standard two photon absorption laser induced fluorescence （TALIF） using xenon for calibration but applied for the first time in the present post discharge hot air plasma column having a temperature of about 4500 K near the axis of the nozzle. The second diagnostic technique is an actinometry method based on optical emission spectroscopy （OES）. In this case, we compared the spectra intensities of a specific atomic oxygen line （844 nm） and the closest wavelength xenon line （823 nm）. The two lines need to be collected under absolutely the same spectroscopic parameters. The xenon emission is due to the addition of a small proportion of xenon （1% Xe） of this chemically inert gas inside the air while a further small quantity of H2 （2~） is also added in the mixture in order to collect OH（A- X） and NH（A-X） spectra without noise. The latter molecular spectra are required to estimate gas and excitation temperatures. Optical emission spectroscopy measurements, at for instance the position z=12 mm on the axis plasma column that leads to a gas measured temperature equal to 3500 K, an excitation temperature of about 9500 K and an atomic oxygen density 2.09× 1017＋ 0.2×1017 cm-3. This is in very good agreement with the TALIF measurement, which is equal to 2.0×101T cm-3.展开更多
The aim of this paper is to obtain relevant sets of collision cross sections of the parent ions in low pressure discharges in argon, oxygen, and nitrogen, i.e., Ar＋ in Ar, O2＋ in O2 and N2＋ in N2. These ion data ar...The aim of this paper is to obtain relevant sets of collision cross sections of the parent ions in low pressure discharges in argon, oxygen, and nitrogen, i.e., Ar＋ in Ar, O2＋ in O2 and N2＋ in N2. These ion data are first discussed and then validated from comparisons between the calculated transport coefficients and those measured in the literature. The elastic momentum transfer collision cross sections are determined from a semi-classical approximation for the phase shift calculation based on a 12-6-4 inter-particle potential while ion transport coefficients are determined versus the reduced electric field from Monte Carlo simulations.展开更多
A swarm analysis technique based on the solution of the Boltzmann equation is used to derive low energy electron collision cross sections for tetramethylsilane （TMS）. The calculated swarm parameters with this first ...A swarm analysis technique based on the solution of the Boltzmann equation is used to derive low energy electron collision cross sections for tetramethylsilane （TMS）. The calculated swarm parameters with this first available cross sections set is consistent with measured values of the swarm parameters. Calculations of transport parameters in mixtures of TMS with argon are also presented.展开更多
The present work is devoted to electrical and optical study of a point-plane atmospheric pressure corona discharge reactor in humid air powered by pulsed high voltage supply. The corona current and the injected energy...The present work is devoted to electrical and optical study of a point-plane atmospheric pressure corona discharge reactor in humid air powered by pulsed high voltage supply. The corona current and the injected energy are analyzed as a function of several parameters such as applied voltage and humidity rate. Then, investigations based on emission spectroscopy analysis were used in UV range (from 200 nm to about 400 nm). The main observed excited species were the second positive (SPS), the first negative (FNS) systems and OH(A-X) rotational bands. The latter band was used to simulate the rotational temperature (Tr), whereas the N2+ (FNS) band was used to determine the vibrational temperature (Tv). The electron temperature (Te ) is determined from the ratio of line intensities of the spectral bands of both N2+ FNS at 391.4 nm and N2SPS at 394.4 nm. The rotational, vibrational and electronic temperatures are analyzed as a function of above parameters (applied voltage, frequency and hygrometry rate) near the anodic tip. As well we study the axial variation of electronic temperature for a fixed applied voltage at 6.4 kV, frequency at 10 kHz and 100% of humidity. It is found that the rotational, vibrational and electronic temperatures increased with increasing applied voltage, frequency and humidity rate. The increase of rate hygrometry for an inter-electrode distance fixed at 10 mm causes an increase in both the amplitude of the corona current discharge and the energy injected in corona discharge. This is indicative of more intense reactive plasma while increasing hygrometry rate.展开更多
文摘Two experimental techniques have been used to quantify the atomic oxygen density in the case of hot air plasma generated by a microwave （MW） resonant cavity. The latter operates at a frequency of 2.45 GHz inside a cell of gas conditioning at a pressure of 600 mbar, an injected air flow of 12 L/min and an input MW power of 1 kW. The first technique is based on the standard two photon absorption laser induced fluorescence （TALIF） using xenon for calibration but applied for the first time in the present post discharge hot air plasma column having a temperature of about 4500 K near the axis of the nozzle. The second diagnostic technique is an actinometry method based on optical emission spectroscopy （OES）. In this case, we compared the spectra intensities of a specific atomic oxygen line （844 nm） and the closest wavelength xenon line （823 nm）. The two lines need to be collected under absolutely the same spectroscopic parameters. The xenon emission is due to the addition of a small proportion of xenon （1% Xe） of this chemically inert gas inside the air while a further small quantity of H2 （2~） is also added in the mixture in order to collect OH（A- X） and NH（A-X） spectra without noise. The latter molecular spectra are required to estimate gas and excitation temperatures. Optical emission spectroscopy measurements, at for instance the position z=12 mm on the axis plasma column that leads to a gas measured temperature equal to 3500 K, an excitation temperature of about 9500 K and an atomic oxygen density 2.09× 1017＋ 0.2×1017 cm-3. This is in very good agreement with the TALIF measurement, which is equal to 2.0×101T cm-3.
文摘The aim of this paper is to obtain relevant sets of collision cross sections of the parent ions in low pressure discharges in argon, oxygen, and nitrogen, i.e., Ar＋ in Ar, O2＋ in O2 and N2＋ in N2. These ion data are first discussed and then validated from comparisons between the calculated transport coefficients and those measured in the literature. The elastic momentum transfer collision cross sections are determined from a semi-classical approximation for the phase shift calculation based on a 12-6-4 inter-particle potential while ion transport coefficients are determined versus the reduced electric field from Monte Carlo simulations.
文摘A swarm analysis technique based on the solution of the Boltzmann equation is used to derive low energy electron collision cross sections for tetramethylsilane （TMS）. The calculated swarm parameters with this first available cross sections set is consistent with measured values of the swarm parameters. Calculations of transport parameters in mixtures of TMS with argon are also presented.
文摘The present work is devoted to electrical and optical study of a point-plane atmospheric pressure corona discharge reactor in humid air powered by pulsed high voltage supply. The corona current and the injected energy are analyzed as a function of several parameters such as applied voltage and humidity rate. Then, investigations based on emission spectroscopy analysis were used in UV range (from 200 nm to about 400 nm). The main observed excited species were the second positive (SPS), the first negative (FNS) systems and OH(A-X) rotational bands. The latter band was used to simulate the rotational temperature (Tr), whereas the N2+ (FNS) band was used to determine the vibrational temperature (Tv). The electron temperature (Te ) is determined from the ratio of line intensities of the spectral bands of both N2+ FNS at 391.4 nm and N2SPS at 394.4 nm. The rotational, vibrational and electronic temperatures are analyzed as a function of above parameters (applied voltage, frequency and hygrometry rate) near the anodic tip. As well we study the axial variation of electronic temperature for a fixed applied voltage at 6.4 kV, frequency at 10 kHz and 100% of humidity. It is found that the rotational, vibrational and electronic temperatures increased with increasing applied voltage, frequency and humidity rate. The increase of rate hygrometry for an inter-electrode distance fixed at 10 mm causes an increase in both the amplitude of the corona current discharge and the energy injected in corona discharge. This is indicative of more intense reactive plasma while increasing hygrometry rate.
