Evaluation of the mold-filling ability of alloy melt in squeeze casting

The mold-filling ability of alloy mclt in squceze casting process was evaluated by means of the maximum length of Archimedes spiral line. A theoretical evaluating model to predict the maximum filling length was built based on the flowing theory of the incompressible viscous fluid. It was proved by experiments and calculations that the mold-tilling pressure and velocity are prominent influencing factors on the mold-filling ability of alloy melt. The mold-filling ability increases with the increase of the mold-filling pressure and the decrease of the proper mold-filling velocity. Moreover, the pouring temperature relatively has less effect on the mold-filling ability under the experimental conditions. The maximum deviation of theoretical calculating values with experimental results is less than 15%. The model can quantitatively estimate the effect of every factor on the mold-filling ability.

Design of process parameters for direct squeeze casting

On the basis of the analysis of solidification interval and temperature distribution of components manufactured by the squeeze casting method, formulas for calculating the solidification interval and compaction pressure were deduced according to the principal request that the compaction pressure should be equal to or greater than the plastic deformation resistance of the forming component when solidification ended. The solidification interval was proven to be associated with many factors, such as weight of the component, specific heat of the alloy, latent heat, pouring temperature, component temperature at the end of solidification and heat-transfer coefficients. The compaction pressure was related to the strain rate, deformation temperature, and dimension of the de- forming component. The solidification interval and compaction pressure calculated by the formulas deduced in this article were adopted in the production of 45 steel bidirectional chapiter valves, and components with excellent oerformance were manufactured.

Abnormal Failure Analysis of H13 Punches in Steel Squeeze Casting Process

In steel squeeze casting process, the working condition of a punch was very rigorous. The abnormal failure models of an H13 punch, such as plastic rubbed damnification, could not be avoided easily. Based on the analysis of the flow stress and the friction-shearing stress of an H13 punch in steel squeeze casting process, the following results were obtained： if the flow stress of an H13 punch was smaller than its friction-shearing stress, these abnormal failures could not be avoided; and if there were some protection measures that enable the flow stress to have a greater value than its friction-shearing one, the abnormal failures would not occur. In the production of 45^# steel valves and catenary system components, the flow stress of a lateral H13 punch without any protection measure was about 29 MPa and its friction-shearing stress was about 51 MPa, then, the abnormal failures occurred; however, when the protection measures of the punch enabled its working temperature to have a value below 682 ℃ its flow stress was greater than its friction-shearing stress, and the abnormal failures were avoided.