Microstructure evolution and mechanical properties of linear friction welded S31042 heat-resistant steel

S31042 heat-resistant steel was joined by linear friction welding （LFW） in this study. The microstructure and the mechanical properties of the LFWed joint were investigated by optical microscopy, scanning electronic microscopy, transmission electron microscopy, hardness test and tensile test. A defect-free joint was achieved by using LFW under reasonable welding parameters. The dynamic recrystallization of austenitic grains and the dispersed precipitation of NbCrN particles resulting from the high stress and high temperature in welding, would lead to a improvement of mechanical property of the welded joint. With increasing the distance flom the weld zone to the parent metal, the austenitic grain size gradually increases from -1 μm to - 150 μm, and the microhardness decreases from 301 HV to 225 HV. The tensile strength （about 731 MPa） of the welded joint is comparable to that of the S31042 in the solution-treated state.

Energy dissipation caused by boundary resistance in a typical reach of the lower Yellow River and the implications for riverbed stability

The energy dissipation of boundary resistance is presented in this paper based on the flow resistance.Additionally,the river morphology responses to the resistance energy dissipation are explored using the Gaocun-Taochengpu reach in the lower Yellow River as a prototype.Theoretical analysis,measured data analysis and a one-dimensional hydrodynamic model are synthetically used to calculate the energy dissipation rate and riverbed morphological change.The results show that the energy dissipation rate along the channel will increase in both the mean value and the fluctuation intensity with increasing discharge.However,the energy dissipation rate will first decrease and then increase as the flow section or width-depth ratio increases.In addition,the energy dissipation rate has a significant positive correlation with the riverbed stability index.The results imply that the water and sediment transport efficiency of the river channel can be improved by optimizing the cross-sectional configuration to fulfil the minimum energy dissipation rate of the boundary resistance under stable riverbed conditions.

Controlled synthesis of high-quality W-Y2O3 composite powder precursor by ascertaining the synthesis mechanism behind the wet chemical method

As an emerging preparation technology,wet chemical method has been employed widely to produce lots of alloy materials such as W and Mo based alloys,owing to its unique technical advantages.Ascertaining the synthesis mechanism behind wet chemical method is indispensable for controlled synthesis of highquality W-Y2 O3 composite powder precursor.The co-deposition mechanism of yttrium and tungsten component behind the wet chemical method of preparing yttrium-doped tungsten composite nanopowder was investigated systematically in this work.A series of co-deposited composite powders fabricated under different acidity conditions were used as research targets for investigating the effect of surface composition and structure on co-deposition efficiency.It was found that white tungstic acid has more W-OH bonds and much higher co-deposition efficiency with Y^3+ions than yellow tungstic acid.It is illustrated that the coordination reaction between W-OH bonds on tungstic acid particles and Y^3+ions brings the co-deposition of yttrium and tungsten component into being.Through displacing H^+ions in W-OH bonds,Y^3+ions can be adsorbed on the surface of or incorporated into tungstic acid particles in form of ligand.Consequently,to control and regulate Y2 O3 content in powder precursor accurately,H^+ion concentration in wet chemical reaction should be in range of 0.55-2.82 mol L^-1 to obtain white tungstic acid.Besides,H^+ion concentration also has prominent effect on the grain size and morphology of reduced powder precursor.The optimal value should be around 1.58 mol L^-1,which can lead to minimum W grain size(about 17 nm) without bimodal structure.The chemical mechanism proposed in this work could produce great sense to preparation of high-quality precursor for sintering high-performance Y2 O3 dispersion strengthened W based alloys.Our work may also shed light on the approach to exploit analogous synthesis mechanism in other alloy systems.