Centralized-local PV voltage control considering opportunity constraint of short-term fluctuation

This study proposes a two-stage photovoltaic(PV)voltage control strategy for centralized control that ignores short-term load fluctuations.In the first stage,a deterministic power flow model optimizes the 15-minute active cycle of the inverter and reactive outputs to reduce network loss and light rejection.In the second stage,the local control stabilizes the fluctuations and tracks the system state of the first stage.The uncertain interval model establishes a chance constraint model for the inverter voltage-reactive power local control.Second-order cone optimization and sensitivity theories were employed to solve the models.The effectiveness of the model was confirmed using a modified IEEE 33 bus example.The intraday control outcome for distributed power generation considering the effects of fluctuation uncertainty,PV penetration rate,and inverter capacity is analyzed.

Induced current of high temperature superconducting loops by combination of exciting coil and thermal switch

With its commercialization, the second-generation(2G) high temperature superconducting(HTS) RE–Ba–Cu–O(REBCO, RE is rare earth) tape is extensively applied to the superconducting magnets in the high magnetic fields. However,unlike low temperature superconducting(LTS) magnets, the HTS magnet cannot operate in the persistent current mode(PCM) due to the immature superconducting soldering technique. In this paper, an exciting method for two HTS sub-loops,so-called charging and load loops, is proposed by flux pump consisting of exciting coil and controllable thermal switch.Two HTS sub-loops are made of an REBCO tape with two slits. An exciting coil with iron core is located in one sub-loop and is supplied with a triangular waveform current so that magnetic field is generated in another sub-loop. The influence of magnetic flux on induced current in load loop is presented and verified in experiment at 77 K. The relationship between the induced magnetic flux density and the current on the sub-loops having been calibrated, magnetic flux density, and induced current are obtained. The results show that the HTS sub-loops can be excited by a coil with thermal switch and the induced current increases with magnetic flux of exciting coil increasing, which is promising for persistent current operation mode of HTS magnets.

Analysis of the Self-Protection Characteristics of a 1.5T Bitter-Like HTS Magnet Operated at 65K

We present a conceptual configuration of a high-temperature superconducting（HTS）magnet made from REBCO（Re=Rare Earth,B=Barium,C=Copper,O=Oxide）annular plates,called a Bitter-like HTS magnet,which can operate in persistent current mode without joint resistance and can be excited by a flux pump and without current leads and a persistent power supply.An REBCO annular magnet which can generate 1.5 T corresponding to the operating current density 80%of critical current density of the magnet at an operating temperature of65 K is conceptually designed.Then the thermal stability of the magnet is numerically simulated by Comsol software.Whein a piece of RBCO annular plate quenches,the maximum released energy is its stored energy because each REBCO annular plate in the Bitter-like magnet is in parallel.To calculate the stored energy in the REBCO annular plate,the inductance of every annular plate,including self-inductance and mutual inductance,is calculated.Compared with the minimum quench energy（MQE）and stored energy in one REBCO annular plate,the stored energy in one REBCO annular plate is always smaller than the MQE,and the REBCO annular plate will not be damaged even though the stored energy in the REBCO annular plate is fully released,which indicates that this 1.5 T Bitter-like magnet has the property of self-protection.

Coordinated Cyber-Physical equipment planning for distributed generation based on chance constrained

With development of distributed generation(DG),configuration of optimization equipment is crucial for absorbing excess electricity and stabilizing fluctuations.This study proposes a two-layer configuration strategy coordinates active cyber control and the physical energy storage(ES)system.First,an upper economic model is developed.Based on chance-constrained programming,an operation model accounts for inherent uncertainty are then developed.Under constraint of voltage risk level,a lower operation model is developed.Finally,a solution based on differential evolution is provided.An IEEE 33 bus system simulation was used to validate efficacy of model.The effects of risk level,equipment price,and chance-constrained probability were analyzed,providing a foundation for power consumption and expansion of cyber-physical systems.

Thermodynamics of Cascaded Waste Heat Utilization from Flue Gas and Circulating Cooling Water

A detailed thermal power plant model was developed to evaluate power plant waste heat usage in terms of the operating parameters,energy consumption,water consumption,and pollutant emissions.This model was used to analyze the bypass flue gas energy cascade utilization design which provides excellent energy savings and emission reductions.This paper then presents a design to use the low-temperature waste heat and to extract water from the flue gas.The low-grade heat can be recovered from a coal-fired unit using absorption heat pumps to increase the air preheating.This method significantly reduces the turbine steam extraction in the low pressure stages which increases the turbine power and reduces the coal consumption.This design has a small heat transfer temperature difference between the air preheater and the air warmer,resulting in a smaller exergy loss.The power output of the present design was 1024.28 MW with a coal consumption savings of 3.69 g·(kWh)^(−1).In addition,the present design extracts moisture out of the flue gas to produce 46.48 t·h^(−1)of water.The main goal of this work is to provide a theoretical analysis for studying complex thermal power plant systems and various energy conservation and CO_(2)reduction options for conventional power plants.

An applicable calorimetric method for measuring AC losses of 2G HTS wire using optical FBG

We present a new calorimetric method for measuring alternative current(AC)losses of high-temperature superconducting(HTS)tapes by optical fiber Bragg grating(FBG),which is particularly well suited for the AC loss measurement of Re BCO wires,so-called the second generation(2G)HTS wires.Compared with conventional calorimetric methods,the suggested method is both free of electromagnetic disturbance,magnetic field,and fast as well as simple.Self-field AC losses are measured by the optical FBG method and the conventional lock-in-amplifier(LIA)technique,respectively.The results show that the measured AC loss is in good agreement with those measured by the electric method,thus the presented calorimetric method would be available for measuring the AC loss of 2G wire and is expected to be generalized for the measurement of AC loss or thermal performances of HTS bulk.