Most heavy crude oils underwent biodegradation and generated a significant amount of naphthenic acids. Naphthenic acids are polar compounds with the carboxylic group and are considered as a major factor affecting the ...Most heavy crude oils underwent biodegradation and generated a significant amount of naphthenic acids. Naphthenic acids are polar compounds with the carboxylic group and are considered as a major factor affecting the oil viscosity. However, the relationship between the molecular composition of naphthenic acids and oil viscosity is not well understood. This study examined a “clean” heavy oil with low contents of heteroatoms but had a high content of naphthenic acids. Naphthenic acids were fractionated by distillation and caustic extraction. The molecular composition was characterized by high-resolution Orbitrap mass spectrometry. It was found that the 2- and 3-ring naphthenic monoacids with 15–35 carbon atoms are dominant components of the acid fractions;the caustic extraction is capable of isolating naphthenic acids with less than 35 carbons, which is equivalent to the upper limit of the distillable components, but not those in the residue fraction;the total acid number of the heavy distillates is higher than that of the residue fraction;the viscosity of the distillation fraction increases exponentially with an increased boiling point of the distillates. Blending experiments indicates that there is a strong correlation between the oil viscosity and acids content, although the acid content is only a few percent of the total oil.展开更多
A Canadian in situ oilsands bitumen-derived vacuum residue(VR)was subjected to supercritical fluid extraction and fractionation(SFEF)into 13 extractable fractions and an unextractable end-cut and characterized by posi...A Canadian in situ oilsands bitumen-derived vacuum residue(VR)was subjected to supercritical fluid extraction and fractionation(SFEF)into 13 extractable fractions and an unextractable end-cut and characterized by positive-and negative-ion electrospray ionization(ESI)Fourier transform ion cyclotron resonance mass spectrometry(FT-ICR MS).The results of negative-ion ESI FT-ICR MS showed that the N1 class species was the most abundant and the multifunctional group compounds,such as N1 O1,N1 O2,N1 S1,N1 S2,and N2 class species became abundant as the SFEF fraction became heavier.In positive-ion ESI mode,the relative abundance of N1 class species decreased gradually in the heavy SFEF fractions while that of multifunctional group compounds increased.The relative abundance of N4 V1 O1 increased dramatically in heavy fractions and the end-cut.The distributions of polar heteroatom species of VR derived from oilsands bitumen were similar with those of VR derived from the Venezuela Orinoco extra heavy oil.展开更多
A vacuum topped Canadian oilsands bitumen (VTB) was subjected to solvent precipitation and subsequently characterized by elemental analysis, gel permeation chromatograph (GPC), 1 H-NMR spectroscopy and negative-ion el...A vacuum topped Canadian oilsands bitumen (VTB) was subjected to solvent precipitation and subsequently characterized by elemental analysis, gel permeation chromatograph (GPC), 1 H-NMR spectroscopy and negative-ion electrospray ionization (ESI) Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS). Effects of experimental conditions such as solvent types (n-C5 , n-C6 , and n-C7 ), solvent purity, and solvent washing time on asphaltenes yields, bulk composition, and molecular composition of detectable heteroatom compounds in ESI source were determined. Elemental nitrogen and sulfur were enriched in asphaltenes while elemental oxygen had comparable content in maltenes and asphaltenes. Molecular composition of asphaltenes varies with separation conditions. The N1 and O1 species identified by ESI FT-ICR MS were enriched in maltenes. The O2 species exhibited two different double bond equivalents (DBE) distributions and solubility in normal paraffin solvents, indicating two types of molecular structures. Multi oxygen atom containing compounds mainly detected in asphaltenes. Compound class distributions are similar for maltenes derived from n-C5 , n-C6 , and n-C7 , as well as for asphaltenes. The cyclic paraffin impurities in normal paraffin solvents had a significant influence on asphaltenes yields and heteroatom molecular composition. A portion of neutral N1 species and acidic O2 species adsorbed on asphaltenes could be dissolved by increasing washing time. Cautions should be exercised when interpreting the properties and composition of asphaltenes obtained with different experimental conditions.展开更多
基金supported by the National Key R&D Program of China(2018YFA0702400)Science Foundation of China University of Petroleum,Beijing(ZX20210029).
文摘Most heavy crude oils underwent biodegradation and generated a significant amount of naphthenic acids. Naphthenic acids are polar compounds with the carboxylic group and are considered as a major factor affecting the oil viscosity. However, the relationship between the molecular composition of naphthenic acids and oil viscosity is not well understood. This study examined a “clean” heavy oil with low contents of heteroatoms but had a high content of naphthenic acids. Naphthenic acids were fractionated by distillation and caustic extraction. The molecular composition was characterized by high-resolution Orbitrap mass spectrometry. It was found that the 2- and 3-ring naphthenic monoacids with 15–35 carbon atoms are dominant components of the acid fractions;the caustic extraction is capable of isolating naphthenic acids with less than 35 carbons, which is equivalent to the upper limit of the distillable components, but not those in the residue fraction;the total acid number of the heavy distillates is higher than that of the residue fraction;the viscosity of the distillation fraction increases exponentially with an increased boiling point of the distillates. Blending experiments indicates that there is a strong correlation between the oil viscosity and acids content, although the acid content is only a few percent of the total oil.
文摘A Canadian in situ oilsands bitumen-derived vacuum residue(VR)was subjected to supercritical fluid extraction and fractionation(SFEF)into 13 extractable fractions and an unextractable end-cut and characterized by positive-and negative-ion electrospray ionization(ESI)Fourier transform ion cyclotron resonance mass spectrometry(FT-ICR MS).The results of negative-ion ESI FT-ICR MS showed that the N1 class species was the most abundant and the multifunctional group compounds,such as N1 O1,N1 O2,N1 S1,N1 S2,and N2 class species became abundant as the SFEF fraction became heavier.In positive-ion ESI mode,the relative abundance of N1 class species decreased gradually in the heavy SFEF fractions while that of multifunctional group compounds increased.The relative abundance of N4 V1 O1 increased dramatically in heavy fractions and the end-cut.The distributions of polar heteroatom species of VR derived from oilsands bitumen were similar with those of VR derived from the Venezuela Orinoco extra heavy oil.
基金supported by the National Natural Science Foundation of China(U1162204 and 21236009)
文摘A vacuum topped Canadian oilsands bitumen (VTB) was subjected to solvent precipitation and subsequently characterized by elemental analysis, gel permeation chromatograph (GPC), 1 H-NMR spectroscopy and negative-ion electrospray ionization (ESI) Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS). Effects of experimental conditions such as solvent types (n-C5 , n-C6 , and n-C7 ), solvent purity, and solvent washing time on asphaltenes yields, bulk composition, and molecular composition of detectable heteroatom compounds in ESI source were determined. Elemental nitrogen and sulfur were enriched in asphaltenes while elemental oxygen had comparable content in maltenes and asphaltenes. Molecular composition of asphaltenes varies with separation conditions. The N1 and O1 species identified by ESI FT-ICR MS were enriched in maltenes. The O2 species exhibited two different double bond equivalents (DBE) distributions and solubility in normal paraffin solvents, indicating two types of molecular structures. Multi oxygen atom containing compounds mainly detected in asphaltenes. Compound class distributions are similar for maltenes derived from n-C5 , n-C6 , and n-C7 , as well as for asphaltenes. The cyclic paraffin impurities in normal paraffin solvents had a significant influence on asphaltenes yields and heteroatom molecular composition. A portion of neutral N1 species and acidic O2 species adsorbed on asphaltenes could be dissolved by increasing washing time. Cautions should be exercised when interpreting the properties and composition of asphaltenes obtained with different experimental conditions.