The optimization of hot compression technique of as-cast 0Cr23Ni13 stainless steel at high strain rate was discussed,and its corrosion resistance was evaluated after hot compression treatment experimentally.By adjusti...The optimization of hot compression technique of as-cast 0Cr23Ni13 stainless steel at high strain rate was discussed,and its corrosion resistance was evaluated after hot compression treatment experimentally.By adjusting the dynamic recrys-tallization(DRX)ratio of 0Cr23Nil3 stainless steel during hot pressing,the content of low Σ coincident site lattice(ΣCSL)grain boundaries is increased,and the grain orientation is optimized.The results show that ferrite and austenite are completely recrystallized at 1050 and 1150℃,respectively.The number of grains in the<111>and<101>directions increases significantly,the corrosion potential increases,and the corrosion current density decreases,which will signifi-cantly improve the corrosion resistance of 0Cr23Nil3 stainless steel.After the optimization of grain boundary distribution,corrosion resistance is noticeably improved due to the existence of lowΣCSL boundaries.The interference effect of lowΣCSL grain boundary on random grain boundary network becomes intense with the increase in DRX ratio,which is the fundamental measure to improve the corrosion resistance.展开更多
基金This research was financially supported by the Science and Technology Major Project of Gansu Province(Grant No.17ZD2GB012)the City Key Research and Development Plan of Jiayuguan(Grant Nos.20-16).
文摘The optimization of hot compression technique of as-cast 0Cr23Ni13 stainless steel at high strain rate was discussed,and its corrosion resistance was evaluated after hot compression treatment experimentally.By adjusting the dynamic recrys-tallization(DRX)ratio of 0Cr23Nil3 stainless steel during hot pressing,the content of low Σ coincident site lattice(ΣCSL)grain boundaries is increased,and the grain orientation is optimized.The results show that ferrite and austenite are completely recrystallized at 1050 and 1150℃,respectively.The number of grains in the<111>and<101>directions increases significantly,the corrosion potential increases,and the corrosion current density decreases,which will signifi-cantly improve the corrosion resistance of 0Cr23Nil3 stainless steel.After the optimization of grain boundary distribution,corrosion resistance is noticeably improved due to the existence of lowΣCSL boundaries.The interference effect of lowΣCSL grain boundary on random grain boundary network becomes intense with the increase in DRX ratio,which is the fundamental measure to improve the corrosion resistance.
